7.COMMAND CENTER ADMINISTRATOR MODE
Setting up From COMMAND CENTER 143
7 COMMAND CENTER ADMINISTRATOR MODE
Installing server certificate automatically
1
Click [Security Service].
The Security Service page is displayed.
2
Enter the items below, and then click [Request] in [Certificate for Server Protocols].
CA Server address — Enter the IP address or FQDN of a CA server within 128 characters.
MFP's Address in Common Name in the Certificate — Select whether to use the IP address or FQDN as the
address of this equipment to be entered in the [Common Name] box of the certificate.
Timeout — Enter a timeout period for quitting communication when no response is received from the CA server.
CA Challenge — Enter the CA challenge.
If FQDN is used in [CA Server address], you need to configure a DNS server and enable DNS settings.
If [FQDN] is selected in [MFP’s Address in Common Name in the Certificate], the IP address of this
equipment must be registered in the DNS server.
A server certificate is installed.
To Next Page
Loading...
