7 COMMAND CENTER ADMINISTRATOR MODE
150 Setting up From COMMAND CENTER
2
Enter the items below, and then click [Request] in [Certificate for IEEE802.1X].
CA Server address — Enter the IP address or FQDN of a CA server within 128 characters.
MFP's Address in Common Name in the Certificate — Select whether to use the IP address or FQDN as the
address of this equipment to be entered in the [Common Name] box of the certificate.
Timeout — Enter a timeout period for quitting communication when no response is received from the CA server.
CA Challenge — Enter the CA challenge.
If FQDN is used in [CA Server address], you need to configure a DNS server and enable DNS settings.
If [FQDN] is selected in [MFP’s Address in Common Name in the Certificate], the IP address of this
equipment must be registered in the DNS server.
A server certificate is installed.
If you want to enable CRL Verification, go to the next step. If not, go to step 5.
3
Select either of [CRL file (PEM)] and [CRL file (DER)] according to the format of a CRL
file that you want to use. Then click [Browse..] to specify a CRL file to be uploaded, and
then click [Upload].
The selected CRL file is uploaded.
To Next Page
Loading...
