Kyocera TASKalfa 650c - Page 155

7.COMMAND CENTER ADMINISTRATOR MODE
Setting up From COMMAND CENTER 153
7 COMMAND CENTER ADMINISTRATOR MODE
Installing CA certificate
When you want to enable SSL and verify with a CA certificate for the LDAP Session, SMTP Client, or POP3 Network
Service, you must install the CA certificate.
You can install up to 10 CA certificates in this equipment.
 P.153 “Installing a CA certificate”
 P.154 “Deleting a CA certificate”
A CA certificate installed using SCEP for server certificates, IPsec certificates or IEEE802.1X certificates will not be
counted into the number of registrations. They can be registered separately.
Installing a CA certificate
1
Click [Security Service].
The Security Service page is displayed.
2
Select the encryption of the CA certificate and click [Browse] to select a CA certificate
file. Then click [Upload].
The CA certificate is installed.
3
Click [Previous] to close the Security Service page.
4
Click [Save] on the Network submenu page.
5
Then you can enable SSL by selecting [Verify with imported cert] for the following
network settings.
 P.115 “Setting up LDAP Session”
 P.123 “Setting up SMTP Client”
 P.126 “Setting up POP3 Network Service”