Kyocera TASKalfa 650c

7 COMMAND CENTER ADMINISTRATOR MODE
162 Setting up From COMMAND CENTER
22)Memory Transmission Report
Select how to print a result report after a memory transmission.
- OFF — Select this to not print a memory transmission report.
- Always — Select this to print a memory transmission report with all page images for each memory transmission
completed.
- ON ERROR — Select this to print a memory transmission report with all page images only when the memory
transmission is not successfully completed.
- Always(Print 1st Page Image) — Select this to print a memory transmission report with the 1st page image for
each memory transmission completed.
- ON ERROR(Print 1st Page Image)
— Select this to print a memory transmission report with the 1st page image
only when the memory transmission is not successful.
23)Multi Transmission Report
Select how to print a result report after a multi-address transmission.
- OFF — Select this to not print a multi-address transmission report.
- Always — Select this to print a multi-address transmission report with all page images for each multi-address
transmission completed.
- ON ERROR — Select this to print a multi-address transmission report with all page images only when the multi-
address transmission is not successfully completed.
- Always (Print 1st Page Image) — Select this to print a multi-address transmission report with the 1st page image
for each multi-address transmission completed.
- ON ERROR (Print 1st Page Image)
— Select this to print a multi-address transmission report with the 1st page
image only when the multi-address transmission is not successful.
24)Polling Report
Select how to print a result report after a multi-polling reception.
- OFF — Select this to not print a multi-polling report.
- Always — Select this to print a multi-polling report for each multi-polling reception.
- ON ERROR
— Select this to print a multi-polling report only when the multi-polling reception is not successful.
25)Relay Originator
Select how to print a result report after a relay transmission.
- OFF — Select this to not print a relay station report.
- Always — Select this to print a relay station report with all page images for each relay transmission completed.
- ON ERROR — Select this to print a relay station report with all page images only when the relay transmission is not
successful.
- Always (Print 1st Page Image)
— Select this to print a relay station report with the 1st page image for each relay
transmission completed.
- ON ERROR (Print 1st Page Image) — Select this to print a relay station report with the 1st page image only when
the relay transmission is not successful.