Kyocera TASKalfa 650c

7.COMMAND CENTER ADMINISTRATOR MODE
Setting up From COMMAND CENTER 181
7 COMMAND CENTER ADMINISTRATOR MODE
3
In the Print Service submenu page, set the Print Service settings as required.
In the Print Service submenu page, you can set the following:
 P.182 “Setting up Raw TCP Print”
 P.182 “Setting up LPD Print”
 P.183 “Setting up IPP Print”
 P.184 “Setting up FTP Print”
 P.185 “Setting up NetWare Print”
 P.185 “Setting up Email Print”
4
Click [Save].
The confirmation dialog box appears.
If you want to restore the current settings without saving the changes, click [Cancel]. Clicking [Cancel] cannot
restore the defaults. This can only clear the changes and restore the current settings before saving the
changes.
5
Click [OK] to apply the changes.
When using Internet Explorer, the changes may not be reflected on the Print Service page immediately after changing
the settings and clicking [Save]. If that happens, click the [Print Service] submenu to refresh the page.