Kyocera TASKalfa 650c

7 COMMAND CENTER ADMINISTRATOR MODE
Setting up User Management 255
3
Click [Department Setting].
The Department Setting page opens.
4
Specify the following items and click [Finish].
 Department Code
Select whether the department management is enabled or disabled.
 Department Code Enforcement
Select whether invalid jobs, for which a department code is not specified or an invalid department code is specified,
are printed or stored in the invalid job list when the department code is enabled.
ON
— Select this to not print the invalid jobs and store them in the invalid job list.
Print — Select this to print the invalid jobs.
Delete — Select this to delete the invalid jobs without storing them in the invalid job list.
 If the Department Code Enforcement is set to ON and the SNMP communication is enabled in the printer
driver, the user will be prompted to enter the correct department code if an invalid department code was
entered in the printer driver.
 The Department Code Enforcement setting is not applied when the User Management Setting is enabled.