7.COMMAND CENTER ADMINISTRATOR MODE
Setting up User Management 259
7 COMMAND CENTER ADMINISTRATOR MODE
7
Enter domain names for the network in the [Domain Name 1], [Domain Name 2] and
[Domain Name 3] boxes, and then click [Detail Setting].
You can specify up to 3 domain names. You must specify at least one domain name to enable the Windows
Domain Authentication.
8
Select the [Use NT Domain Server] check box, and enter the following items. Then click
[Next].
Domain Name — The domain name entered in Step 6 is displayed.
PDC — Enter the server name or IP address of the Primary Domain Controller.
BDC — Enter the server name or IP address of the Backup Domain Controller as required.
Connection Timeout — Enter timeout period for quitting communication when no response is received form PDC
or BDC server in 1 to 180 seconds.
If the wrong primary or backup domain controller is specified, the [OK] in the user authentication screen on the
touch panel is highlighted while this equipment searches for the primary or backup domain controller for 2 to 4
minutes. In that case, correct the primary or backup domain controller setting after the beep sounds and the
alert message will be displayed on the touch panel.
To Next Page
Loading...
