Lanmage 6600C - Page 91

6600 Product Manual
Operator Manual
79
53
High Large Focus Filament Current Error in Standby
54
AEC Reference out of range
55
No Fields Selected in AEC mode
56
No Tube Programmed
57
AEC Stop signal in wrong state
60
High KV Error
61
Low KV Error
71
Boost filament current error
72
Preheat filament current error
73
Film screen is invalid
74
DC BUS voltage is too higher or too low
75
Tube count data corrupt
100
Calibration Error - Maximum mA Exceeded
101
Calibration Error - Calibration Data Table Exceeded
102
Calibration Error - Maximum Filament Current Exceeded
103
Calibration Error - Manually Terminated
104
Calibration Error - No mA
105
Calibration Error - Minimum mA not calibrated
106
Generator Limit, Selected Parameter Not calibrated
107
pre-charge relay fault
108
large filament set parameter is more than max. filament current
109
small filament set parameter is more than max. filament current.
200
Anode Warning Level Exceeded
202
Generator KW Limit
203
Generator KV Limit
204
Generator MA Limit
205
Generator MS Limit
206
Generator MAS Limit
207
Tube KW Limit
208
Tube KV Limit
209
Tube MA Limit
210
Tube MAS Limit
212
Generator AEC Density Limit
213
Invalid Communication Parameter
214
Housing Heat Warning2