What causes a LeeBoy Accessories machine to not pull on one side?
If your LeeBoy Accessories machine isn't pulling on one or both sides, check the following: * **Faulty hydraulic motor:** Replace the hydraulic motor. * **Low pump pressure:** Check the pump pressure and relieve or adjust it as necessary. * **Faulty torque hub:** Rebuild or replace the torque hub.
What to do if my LeeBoy Accessories machine doesn't change speed with the 2-Speed switch?
If your LeeBoy Accessories machine isn't changing speed when you engage the 2-Speed switch, it could be due to: * **Defective relay:** Replace the relay. * **Defective solenoid:** Replace the solenoid. * **Defective drive motor:** Replace the drive motor.
What causes the auger on my LeeBoy Accessories to not turn properly?
If the auger on your LeeBoy Accessories isn't turning properly, check the following: * **Loose drive chain:** Adjust the drive chain. * **Broken drive chain:** Replace the drive chain. * **Faulty motor:** Replace the motor. * **Defective solenoid valve:** Replace the solenoid. * **Asphalt buildup:** Clean thoroughly and grease the auger. * **Material overload:** Set the conveyor to the proper speed in AUTO or use paddles in the MANUAL position.
Why isn't the conveyor functioning on my LeeBoy 8515D Accessories?
If the conveyor isn't functioning on one or both sides of your LeeBoy Accessories, here are some possible causes: * **Defective Automatic/Manual switch:** Replace the switch. * **Defective Solenoid:** Replace the solenoid. * **Broken feeder drive chain:** Repair or replace the chain. * **Defective conveyor motor:** Replace the motor. * **Broken rear conveyor shaft:** Replace the shaft.
Why is my LeeBoy 8515D screed leaving a streak down the center of the pavement?
If your LeeBoy Accessories screed is leaving a streak down the center of the pavement, consider these factors: * **No lead crown:** Crown the leading edge of the screed. * **Worn or damaged screed:** Replace the screed. * **Extensions set too low:** Adjust the extension. Always begin operation with extensions extended up with no down pressure. * **Improperly heated screed:** Check the elements and heat control box.
General and specific safety guidelines for product and safety label locations.
Details the screed's function, extensions, and heating systems.
Identifies and describes the controls on the left operator panel.
Details the general operating controls and the digital display unit.
Essential pre-operation inspection of the unit's general condition and systems.
Step-by-step guide for safely starting the paver's engine and systems.
Details the functions and information displayed on the PV480 digital display.
Instructions for safely operating the paver, including steering and speed control.
Procedure for adjusting the screed to control pavement slope for drainage.
How to adjust the screed for a smoother or coarser mat texture.
Procedures for safely loading and unloading the paver from a transport trailer.
Outlines the periodic maintenance tasks based on operating hours.
Identifies common symptoms, causes, and remedies for mechanical problems.
Lists diagnostic trouble codes, symptoms, and recovery procedures.
General| Brand | LeeBoy |
|---|---|
| Model | 8515D |
| Category | Accessories |
| Language | English |
To Next Page
