LeeBoy L600 - Page 15

The safety messages that follow have WARNING
level hazards.
Crush HazardCrush Hazard
Keep bystanders away from work area before and
during operation.
Modification HazardModification Hazard
Never modify the machine without the written consent
from LeeBoy. Any modication can affect the safe
operation of the machine and may cause personal injury
or even death.
Exposure HazardExposure Hazard
Operators of the machine must be aware of
their work environment and the equipment
needed to work safely.
• Always wear personal protective equipment, including
appropriate clothing, gloves, work shoes, and
protection for eyes and ears, as required by the task
at hand.
Explosion HazardExplosion Hazard
While the engine is running or the battery is
charging (if equipped with battery option),
hydrogen gas is produced that can ignite.
Keep the battery area well-ventilated and
keep sparks, open ame, and any other
form of ignition away from the machine.
• Always disconnect the negative (-) battery cable
before servicing the machine.
• DO NOT start the engine by “shorting” the starter
circuit or any other starting method not stated in this
manual.
• Never charge a frozen battery. Always warm the
battery slowly to room temperature before charging.
• Never refuel with the engine running.
• Store any containers containing fuel in a well-
ventilated area, away from any combustibles or
sources of ignition.
Fire and Explosion HazardFire and Explosion Hazard
• Fuel is ammable and explosive under certain
conditions.
• Clean up fuel spills immediately.
• Never refuel while the engine is running.
• Store fuel containers in a well-ventilated area away
from any combustibles or sources of ignition.
Fire HazardFire Hazard
When operating machinery, there is always
a risk for re. Ensure appropriate safety
equipment available.
• Keep a charged re extinguisher within reach at all
times.
• Ensure all re extinguishers are checked periodically
for proper operation and readiness.
• Always read and follow safety-related precautions
on hazardous substance containers like cleaners,
primers, sealants and sealant removers.
• Undersized wiring systems can cause electrical res.
Entanglement/Sever HazardEntanglement/Sever Hazard
• Verify there are no people, obstacles or other
equipment near the machine or in its path before
starting the engine.
• If the engine must be serviced while it is operating,
remove all jewelry and tie back long hair.
• Stay clear of moving/rotating parts.
• Always stop the engine before performing
maintenance and remove the negative battery cable.
• Verify that all guards and covers are properly attached
before starting the engine. DO NOT start the engine if
any guards or covers are not properly installed.
• If you must operate the engine during maintenance
procedures, keep bystanders clear of the area.
• Attach a “Do Not Operate” tag near the key switch
while performing maintenance on the equipment.
• Never operate the engine while wearing headphones
because it will be difcult to hear any warning signals.
11
Safety
L300 and L600 Tack Distributors 1-5