Alcohol and Drug HazardAlcohol and Drug Hazard
Never operate the machine while under the
inuence of alcohol or drugs.
Flying Object HazardFlying Object Hazard
Always wear eye protection when cleaning
the machine with compressed air or high-
pressure water.
Dust, ying debris, compressed air,
pressurized water or steam may cause eye
injury.
Burn HazardBurn Hazard
Some of the machine’s surfaces become
very hot during operation and may remain
hot for a few minutes after shutdown.
• Keep hands and other body parts away from hot
machine surfaces.
• Handle hot components with heat-resistant gloves.
The safety messages that follow have NOTICE level
hazards.
Any part that is found defective as a result of inspection
or any part whose measured value does not satisfy the
standard or limit must be replaced.
Always tighten components to the correct torque. (See
Section 2, Torque Tables) Loose parts can cause
improper operation and damage to the machine. Only
use replacement parts approved by LeeBoy. Other
replacement parts may affect warranty coverage.
Contact your authorized dealer for assistance.
Follow EPA and local government
guidelines for properly disposing of
hazardous materials such as engine oil,
diesel fuel, and engine coolant. Consult
local authorities or reclamation facilities
for more information. Never dispose of
hazardous materials by dumping them into a sewer, on
the ground, or into waterways.
Clean all accumulated dirt and debris away from
the body of the machine and its components before
inspecting the machine or performing repairs and
maintenance. Operating a machine with accumulated
dirt buildup will cause premature wear of machine
components and hinders effective operation.
If any alert indicator illuminates while operating, STOP
the engine immediately. Determine the cause and repair
the problem before continuing to operate the machine.
Contact your authorized dealer for service assistance.
Safety
L300 and L600 Tack Distributors1-6
To Next Page
Loading...
