A video of this procedure is available at YouTube: https://www.youtube.com/playlist?list=PLYV5R7hVcs-
CTkyVDu-5Lhy1r9G-4PQGl
.
Procedure
Step 1. Remove the top cover. See “Remove the top cover” on page 150.
Step 2. Disconnect the cable of the RAID flash power module.
Step 3. Remove the RAID flash power module on the chassis.
Figure 81. Removal of the RAID flash power module on the chassis
a.
Open the retention clip on the holder of the RAID flash power module.
b.
Take the RAID flash power module out of the holder.
Step 4. Remove the RAID flash power module holder as shown if necessary.
Figure 82. RAID flash power module holder removal
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Chapter 5. Hardware replacement procedures 119
To Next Page
Loading...
