a. Slide the release latch to the left to open the drive tray handle.
b.
Open the drive handle.
c.
Slide the drive out of the drive bay.
After you finish
1. Install a drive filler or a new drive to cover the drive bay.
Figure 43. Install a drive filler
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Install a 2.5/3.5-inch hot-swap drive
Use this information to install a 2.5/3.5-inch hot-swap drive.
Chapter 5. Hardware replacement procedures 69
To Next Page
Loading...
