The following illustrates how to install the front I/O module with front operator panel. You can install other
front I/O modules in the same way.
Attention:
• Read
“Installation Guidelines” on page 35 and “Safety inspection checklist” on page 36 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 44.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
CTkyVDu-5Lhy1r9G-4PQGl
.
Procedure
Step 1. Touch the static-protective package that contains the front I/O module to any unpainted surface on
the outside of the server. Then, take the front I/O module out of the package and place it on a
static-protective surface.
Step 2. Install the front I/O module.
Figure 33. Install a front I/O module on 2.5'' chassis
Figure 34. Install a front I/O module on 3.5'' chassis
a.
Insert the front I/O module into the front chassis.
b.
Install the screws to secure the front I/O module in place.
After you finish
1. Install the front VGA filler or connect the front I/O cables to the system board (system board assembly).
See
Chapter 6 “Internal cable routing” on page 157.
2. Complete the parts replacement. See
“Complete the parts replacement” on page 154.
Remove the external LCD cable (4 x 3.5'' chassis)
Use this information to remove the external LCD cable.
Chapter 5. Hardware replacement procedures 63
To Next Page
Loading...
