Install the internal CFF HBA/RAID adapter
Use this information to install the internal CFF HBA/RAID adapter.
About this task
Attention:
• Read
“Installation Guidelines” on page 35 and “Safety inspection checklist” on page 36 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 44.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
CTkyVDu-5Lhy1r9G-4PQGl
.
Procedure
Step 1. Touch the static-protective package that contains the internal CFF HBA/RAID adapter to any
unpainted surface on the outside of the server. Then, take the internal CFF HBA/RAID adapter out
of the package and place it on a static-protective surface.
Step 2. Align the notches on the tray with the pins on the chassis, place down the internal CFF HBA/RAID
adapter, and slightly slide it as shown to secure it on the chassis.
Figure 47. Internal CFF HBA/RAID adapter installation
Step 3. Connect cables to the internal RAID adapter. See
“CFF RAID adapter” on page 159.
After you finish
Chapter 5. Hardware replacement procedures 73
To Next Page
Loading...
