1. Connect the RAID flash power module to an adapter with the extension cable that comes with the flash
power module. See
“RAID flash power modules” on page 162.
2. Complete the parts replacement. See
“Complete the parts replacement” on page 154.
Riser card replacement
Use this information to remove and install a riser card.
The server supports the following riser cages:
Table 18. Riser cages
Riser 1 cage Riser 2 cage
Figure 86. Low profile-full height (LP-FH) cage
Figure 87. Low profile (LP) cage
Figure 88. Low profile-low profile (LP-LP) cage
The removal or installation procedure of the riser card is similar to that of all types of riser assembly. The
following takes the LP-FH riser assembly as an example.
•
“Remove a riser card” on page 122
• “Install a riser card” on page 125
Remove a riser card
Use this information to remove a riser card.
About this task
For more riser brackets supported, see “The overview of riser bracket types” on page .
122
ThinkSystem SR645 V3 User Guide
To Next Page
Loading...
