Step 3. If the server does not have a RAID flash power module holder on the chassis, install one first. Put
the holder down, and move it to the direction as shown to lock the holder onto the chassis.
Figure 84. RAID flash power module holder installation
Step 4. Install the RAID flash power module on the chassis.
Figure 85. Installation of the RAID flash power module on the chassis
a.
Open the retention clip on the holder.
b.
Put the RAID flash power module into the holder and press it down to secure it into the
holder.
After you finish
Chapter 5. Hardware replacement procedures 121
To Next Page
Loading...
