Lenovo ThinkSystem SR645 V3 - Internal CFF HBA;RAID Adapter Replacement; Remove the Internal CFF HBA;RAID; Adapter

Step 3. Install the drive in the drive bay.
Figure 45. Hot-swap drive installation
a.
Ensure that the drive tray handle is in the open position. Slide the drive into the drive bay
until it snaps into position.
b.
Close the drive tray handle to lock the drive in place.
Step 4. Check the drive LEDs to verify that the drive is operating normally. For details, see
“Drive LEDs” on
page 186
.
Step 5. Continue to install additional hot-swap drives if necessary.
After you finish
1. Reinstall the security bezel if you removed it. See
“Install the security bezel” on page 129.
2. Use the Lenovo XClarity Provisioning Manager to configure the RAID if necessary. For more information,
see:
https://sysmgt.lenovofiles.com/help/topic/lxpm_frontend/lxpm_product_page.html
Internal CFF HBA/RAID adapter replacement
Use this information to remove and install the internal CFF HBA/RAID adapter.
•
“Remove the internal CFF HBA/RAID adapter” on page 71
• “Install the internal CFF HBA/RAID adapter” on page 73
Remove the internal CFF HBA/RAID adapter
Use this information to remove the internal CFF HBA/RAID adapter.
About this task
Attention:
Chapter 5. Hardware replacement procedures 71