Figure 91. Rear wall bracket removal
Install a riser card
Use this information to install a riser card.
About this task
For more riser brackets supported, see
“The overview of riser bracket types” on page .
The riser assembly you want to install might be different from the following illustrations, but the installation
method is the same. The following takes the LP-FH riser assembly as an example.
Attention:
• Read
“Installation Guidelines” on page 35 and “Safety inspection checklist” on page 36 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 44.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
CTkyVDu-5Lhy1r9G-4PQGl
.
Procedure
Step 1. Touch the static-protective package that contains the riser card to any unpainted surface on the
outside of the server. Then, take the riser card out of the package and place it on a static-protective
surface.
Chapter 5. Hardware replacement procedures 125
To Next Page
Loading...
