Server replacement
Follow instructions in this section to remove and install the server.
•
“Remove the server from rack” on page 45
• “Install the server to rack” on page 48
Remove the server from rack
Follow instructions in this section to remove the server from the rack.
S036
18 - 32 kg (39 - 70 lb) 32 - 55 kg (70 - 121 lb)
CAUTION:
Use safe practices when lifting.
S006
CAUTION:
When laser products (such as CD-ROMs, DVD drives, fiber optic devices, or transmitters) are
installed, note the following:
• Do not remove the covers. Removing the covers of the laser product could result in exposure to
hazardous laser radiation. There are no serviceable parts inside the device.
• Use of controls or adjustments or performance of procedures other than those specified herein
might result in hazardous radiation exposure.
About this task
Attention:
• Read
“Installation Guidelines” on page 35 and “Safety inspection checklist” on page 36 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 44.
CAUTION:
Make sure to have three people operate the server removal procedures to prevent injury.
Watch the procedure
Chapter 5. Hardware replacement procedures 45
To Next Page
Loading...
