• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 44.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
CTkyVDu-5Lhy1r9G-4PQGl
.
Procedure
Step 1. Touch the static-protective package that contains the external LCD cable to any unpainted surface
on the outside of the server. Then, take the external LCD cable out of the package and place it on a
static-protective surface.
Step 2. Install the external LCD cable.
Figure 42. Installation of the external LCD cable
Note: The front and back sides of the connector to external diagnostics slot are different, and it is
required to plug in with the front side.
When plugging in, face the front side upward and slide the connector into the chassis. Refer to the
illustration above.
After you finish
1. Connect the external LCD cable to the processor board. See Chapter 6 “Internal cable routing” on page
157
.
2. Complete the parts replacement. See
“Complete the parts replacement” on page 154.
Chapter 5. Hardware replacement procedures 67
To Next Page
Loading...
