Configuration
Code table
8
8.5

8.5−3
EDSVF9383V EN 4.0−03/2006
IMPORTANTPossible settingsCode
SelectionLenzeNameNo.
C0010 N
min
0 0 {1 rpm} 36000
l Reference value
for the absolute
and relative
setpoint selection
for the
acceleration and
deceleration
times
l C0059 must be
set correctly
l Set C0010 <
C0011
l C0010 is only
effective in case
of analog setpoint
selection via AIN1
Important: For
parameter setting
via interface, major
changes in one step
should only be made
when the controller
is inhibited.
Minimum
speed

6.10−1
C0011 N
max
3000 0 {1 rpm} 36000 Maximum
speed
C0012 Tir (acc) 5.00 0.00 {0.01 s} 9999.90 Acceleration time T
ir
of the main
setpoint
l Refers to speed change
0 ... C0011

6.10−3
C0013 Tif (dec) 5.00 0.00 {0.01 s} 9999.90 Deceleration time T
if
of the main
setpoint
l Refers to speed change
0 ... C0011
C0014 V/f charact. 0
Characteristic in the V/f
characteristic control mode

8.2−25
0 Linear Linear V/f characteristic
1 square Square V/f characteristic
C0015 Rated freq 50 10 {1 Hz} 5000 V/f−rated frequency
In C0015 you can set a base
frequency which differs from the
rated motor frequency (C0089)
l Lenze setting: C0015 = C0089
l Changing C0086 or C0089
overwrites the value in C0015

8.2−25
C0016 Umin boost 0.00 0.00 {0.01 %} 100.00 U
min
boost (FCODE)
l C0016 = 1 % corresponds to a
boost of 1 % of the rated motor
voltage (C0090)
l Code is freely configurable
 6.8−4
C0017 FCODE (Qmin) 50 −36000 {1 rpm} 36000 Q
min
−switching threshold (FCODE)
l Programmable speed threshold
l If the current speed is < C0017,
CMP1−OUT is activated.
l Freely configurable code
To Next Page
Loading...
Need help?
General
