Need help?Do you have a question about the Levelcom 100 and is the answer not in the manual?
Details compliance with industry standards and product certifications.
Covers power, operating range, humidity, and enclosure details.
Specifies tank sensing ranges, accuracy, resolution, and supply air pressure.
Explains the principle of bubbler systems for liquid level measurement.
Describes the LevelCom 100's pulsed bubbler operation and measurement capabilities.
Defines terms like Bubbler, Buttons, Calibration, Communication, and Configuration.
Explains features such as Hot Menu, Hysteresis, Latch, and Password.
Details the bargraph and digital display for level indication and alarms.
Lists and explains system error messages like LEAK 1, CAN'T ZERO SENSOR, CHECK AIR.
Covers pipe size, materials, mounting strategies, and special cases.
Discusses specific installation types like drill mud and viscous liquids.
Guidelines for choosing a location and preparing for mounting.
Details surface mounting, multiple unit mounting, and flush mounting.
Step-by-step guide for connecting 115VAC and 24VDC power.
Details on setting up the 4-20 mA analog output and optional relays.
Setup for serial communication using RS-422/485, including terminals and protocol.
Configures the interface for LevelCom 101 repeaters.
Explains the function and connection of each pneumatic port.
Guidance on tubing setup, slope, and the importance of clean air supply.
Steps to enter programming, navigate menus, and reset to factory defaults.
Configures display units, sample/purge timing, and specific gravity.
Defines tank shape for accurate volume/weight calculations in non-linear tanks.
Secures configuration with a password and sets up quick-access Hot Menu.
Configures front panel lights, horn, and optional relays for alarms/control.
Sets up the 4-20 mA output for gauge or control functions.
Step-by-step guide for field calibrating the pneumatic pressure sensor.
Procedure to check and adjust the 4-20 mA analog output signal.
Diagnoses CAN'T ZERO SENSOR, EEPROM FAILURE, and CHECK AIR messages.
Addresses CALIBRATE menu utilities and output troubleshooting.
Steps to troubleshoot Modbus communication, including protocol and errors.
Details on accessing and configuring hardware options like sensors and SG.
Provides serial network wiring diagrams and Modbus register values.
Guides to navigate the LevelCom 100 configuration interface using diagrams.
To Next Page
General