Levelcom 100 - Hardware Menu and Appendices; Hardware Configuration Options

To Next Page

To Previous Page

Page 86

operator. They are automatically detected by the LevelCom 100 when it first starts operation,

and the devices detected are shown here for troubleshooting. There are some options that

can be changed here though; Automatic Specific Gravity, Differential Pressure, Passive

Gauge, and Sample Timing.

It is very important to understand the function of the configurable parameters before

changing them. If these are set up incorrectly the machine will not function correctly.

Operators should contact TMS before changing any of these settings. It is important to

understand what each option does. The following section describes all options under the

HARDWARE.

Accessing the Hardware menu

First you must set up temporary a password in the LevelCom 100 if there isn’t already a

password programmed (A for example). If there is already a password programmed into the

machine you don’t have to change it. You need a password in the machine so that you will

be asked to enter a password before entering the operator interface.

Now enter the configuration menus, when the machine asks for you to enter the password,

use the special password SETXYZ.

After entering the password the machine will display SYSTEM. Press UP and the machine

will display UTILITIES.

Press ENTER, the machine will display COMM SETUP. Press UP and the machine will

display HARDWARE. This is the special hardware configuration menu. You must enter the

configuration interface using the password SETXYZ to have access to this menu. Normally it

isn’t available in the UTILITIES menu.

Press ENTER, the machine will display 15 PSI.

The menu begins with a list of possible pressure sensor types and other optional hardware

installed. You will see an asterisk * in the rightmost character in the interface identifying the

options installed. If an option can be activated by the operator, the MENU key is pressed to

activate or de-activate that item. In this case the asterisk indicates that the item is active.

The list with descriptions of each item is as follows. You will use the DOWN arrow button to

scroll through this list:

15 PSI: A 15 psi sensor is installed. Not modifiable.

30 PSI: A 30 psi sensor is installed. Not modifiable.

100 PSI: A 100 psi sensor installed. Not modifiable.