Page 40
©2013 Technical Marine Service, Inc. LC-100 V2.97
36. Press UP or DOWN to scroll to the specific gravity distance using the Depth Units you
selected in step #5 above.
37. Press ENTER to save. SAVING will appear briefly on the display and the display will shift
to MAX DEPTH.
38. Press ESCAPE. Unit will display DISPLAY SETUP.
39. Proceed with the next programming step or press ESCAPE twice to return to normal
operation.
Sample and Purge Timing
The Timing program establishes three parameters. Sample and Purge regulate the
frequency of level samples and purge functions. Purge Duration allows the operator to set
the amount of time (from 5 to 180 seconds) required for a complete purge of the sense line
system.
1. At DISPLAY SETUP press DOWN. Unit will display TIMING.
2. Press ENTER. Unit will display SAMPLE.
3. Press ENTER. Unit will display AUTO.
Note: Selecting Auto will force the Level-
Com 100 to automatically take a sample whenever a change in level is detected. Auto and a
predetermined sample interval can be selected at the same time. If the tank being monitored
is subject to rolling, Auto will force the LevelCom 100 to chase the level in the tank as the
vessel rolls. Consider alarm/control issues when selecting the Auto feature.
4. Press UP or DOWN to scroll to the sample cycle time you have chosen for use.
5. Press MENU to select the choice. An asterisk (*) will appear to the right of the display
indicating the item has been selected.
6. Press ENTER to save the selection. SAVING will appear briefly on the display and the
display will shift to SAMPLE.
7. Press DOWN. Unit will display PURGE.
8. Press ENTER. Unit will display 1 HR.
9. Press UP or DOWN to scroll to the purge cycle time you have chosen for use.
10. Press MENU to select the choice. An asterisk (*) will appear to the right of the display
indicating the item has been selected.
To Next Page
Loading...