Page 43
©2013 Technical Marine Service, Inc. LC-100 V2.97
specific gravity value though so you should only use the filter value needed. The filter is a
simple digital filter that works in the following way. The current specific gravity value is
multiplied by the filter value, then the new specific gravity reading is added to this, finally the
result is divided by the filter value plus one. As an equation it looks s like this:
((SGo * Filter) + SGn)/(Filter +1)
SGo is the current value of specific gravity
SGn is the new specific gravity reading
Filter is the filter value
A filter value of 0 disables the filter.
To configure the specific gravity filter value use the following procedure.
1. At TIMING press DOWN. Unit will display SPEC GRAV.
2. Press ENTER. Unit will display AUTO.
3. Press DOWN until unit displays FILTER SETUP.
4. Press ENTER. Unit will display the current filter value, the default is 0.
5. Press UP or DOWN to scroll to the desired filter value.
6. Press ENTER to save the value. SAVING will appear briefly on the display and the
display will shift to DISPLAY SETUP.
7. Press ESCAPE three times to return to normal operation.
Configuring Output Lights
This setup assumes that there are no optional outputs installed in the LevelCom 100. See
the Advanced Programming section for configuring the optional outputs. This section only
describes the alarm lights on the LevelCom 100 front panel.
1. At SYSTEM press DOWN. Unit will display OUTPUTS.
2. Press ENTER. Unit will display LIGHTS.
3. Press ENTER. Unit will display HI HI.
4. Press UP or DOWN to scroll to the ALARM points you wish to be indicated on the front
panel alarm indicator lamps. Press MENU to select choices. An asterisk (*) will appear
to the right of the display indicating the alarm points that have been activated.
To Next Page
Loading...