Page 42
©2013 Technical Marine Service, Inc. LC-100 V2.97
LevelCom 100 will revert to manual specific gravity operation. In this case the manual
specific gravity value is used.
To set the manual specific gravity value use the following procedure.
1. At TIMING press DOWN. Unit will display SPEC GRAV.
2. Press ENTER. Unit will display AUTO.
3. Press DOWN. Unit will display MANUAL.
4. Press MENU. An asterisk (*) will appear to the right of the display indicating the item has
been selected.
5. Press ENTER. Unit will display the current manual specific gravity value, 1.000 is the
default value.
6. Press UP or DOWN to scroll to the specific gravity of the liquid most likely to be stored in
the tank.
7. Press ENTER to save the value. SAVING will appear briefly on the display and the
display will shift to MANUAL.
8. Proceed with the next programming step or press ESCAPE three times to return to
normal operation.
With the manual specific gravity value set up use the following procedure to put the
LevelCom 100 into the Automatic Specific Gravity mode.
1. At TIMING press DOWN. Unit will display SPEC GRAV.
2. Press ENTER. Unit will display AUTO.
3. Press MENU. An asterisk (*) will appear to the right of the display indicating the item has
been selected.
4. Press ENTER. Unit will display the current specific gravity value. The LevelCom 100 is
now operating in Automatic Specific Gravity mode, however if you just selected this mode
in this step the value displayed will initially be the manual specific gravity value. The
LevelCom 100 will have to go through at least one sample operation to update the
specific gravity value.
5. press ESCAPE three times to return to normal operation.
Note: There is a digital filter that can be set up to reduce noise in the specific gravity
reading. Using this filter will slow the LevelCom 100’s reaction to changes in the actual
To Next Page
Loading...