Page 62
©2013 Technical Marine Service, Inc. LC-100 V2.97
3. Press ENTER. The unit will display LIGHTS.
4. Press the DOWN key until unit displays ANALOG OUTPUT.
5. Press ENTER. The unit will display GAUGE.
6. Press DOWN key until unit displays CONTROL.
7. Press MENU to select this function if it isn’t already selected. An asterisk (*) will appear to
the right of the display indicating the function has been selected.
8. Press ENTER. SAVING will appear briefly on the display. The unit will display MIN
SETPOINT.
9. Press the UP or DOWN keys to scroll to the MANUAL.
10. Press MENU to select the manual mode. An asterisk (*) will appear to the right of the
display indicating the function has been selected.
11. Press ENTER. The unit will display 0.0%. The display shows percent of output signal
now, 0% is 4 mA and 100% is 20 mA.
12. Press the UP or DOWN keys to scroll to the output signal level you want.
The machine may be returned to normal operation now if you want to leave a manual output
value on the machine. In this case press ESCAPE to return to normal operation. The
machine will flash the word MANUAL on the display every few seconds to indicate that it is in
manual analog output mode.
If you want to return to a controlled analog output follow the instructions from here.
1. Press ESCAPE. The display will shift to MANUAL. There will be an asterisk (*) indicating
that the machine is in Manual mode.
2. Press MENU to clear the asterisk.
3. Press ENTER. SAVING will appear briefly on the display and the display will say
MANUAL with no asterisk. The machine will now automatically run the analog output.
4. Press ESCAPE to return to normal operation.
Note: If the machine is to run as a gauge output make sure to switch it back to GAUGE
before leaving this menu.
Digital Communication Interface
To Next Page
Loading...