Levelcom 100 - Advanced Programming

To Next Page

To Previous Page

Page 48

Advanced Programming

This section addresses the programming of the more advanced features of the LevelCom

100. These features include setting up a Tank Table, establishing password protection of the

LevelCom 100 configuration, setting up a Hot Menu, and the setup of optional outputs.

This section assumes the LevelCom 100 has been programmed for basic use. If the unit has

not been programmed please refer to page 35, Basic Programming.

Use caution as you move through the program. If you inadvertently access a section of the

program containing data you do not wish to adjust, simply press ESC to back out to the

previous program point. Following the Configuration Flow Chart as you move through the

program will assist you.

Entering the Program Mode

From normal operation press MENU. The Program Mode indicator lamp will light. The unit

will display SYSTEM.

Note: If the unit displays ENTER PASSWORD or HOT MENU then the LevelCom 100 has

been previously programmed. Confer with the responsible party prior to proceeding. If the

unit displays HOT MENU please refer to the following section. If the unit displays ENTER

PASSWORD and the password is not available please call TMS for assistance.

Entering the Program Mode with A Hot Menu established

The LevelCom 100 program allows the user to establish a Hot Menu, which allows access to

selectable parameters and functions without the need to enter the program. The Hot Menu feature

provides a means to access and adjust commonly used features, e.g., alarm and relay setpoints,

specific gravity, sample timing, etc. without entering into the full program. Items available for the Hot

Menu are indicated on the Configuration Flow Chart. For instructions on programming a Hot Menu

please turn to page 52.

Once programmed, the Hot Menu is instantly accessible from normal operation simply by pressing the

MENU key.

If a Hot Menu is set up, then entering the Program Mode requires some additional steps.

1. From normal operation press MENU. Program Mode indicator lamp will light. The unit

will briefly display HOT MENU and the display will shift to the first Hot Menu selection.

2. Press the UP key. The unit will display CONFIGURE SYSTEM.

3. Press ENTER. If no password is required, the unit will display SYSTEM. For information

on passwords please see Page 51.