Levelcom 100 - Entering Program Mode and Reset

To Next Page

To Previous Page

Page 36

MENU: Places the unit into Program Mode. Also

selects/deselects functions.

UP/DOWN: Scroll vertically through the menu. They are

also used to adjust parameter values.

ENTER: Used to enter the next program level, save

selections and parameter values.

Note: Prior to programming it is recommended that the

operator complete the Programming Worksheet found on

page 70.

The Programming Worksheet contains all user selectable

settings and follows the sequence used in programming the

LevelCom. Use of the Programming Worksheet will ensure

that you will have at your fingertips all of the data required

for complete programming of the LevelCom 100. Save the

worksheet for your files.

Entering the program mode

Open the front cover and power up the LevelCom 100 using the power on/off switch. The

unit will initialize and display a numerical value. Close the cover.

Press MENU. The unit will display SYSTEM. You are now in the LevelCom configuration

interface.

Note: If the unit displays ENTER PASSWORD or HOT MENU then the LevelCom 100 has

been previously programmed. Confer with the responsible party prior to proceeding. Note

that one of the benefits of the LevelCom 100 is this very ability to modify the configuration at

will.

If the unit displays HOT MENU please refer to Page 48. If the unit displays ENTER

PASSWORD and the password is not available, please call TMS for assistance.

Erase All Memory Reset Factory Defaults

Note: This section will remove all selections and parameters from memory and the unit will

reset to factory defaults. Use this section only if you have previously entered the program

and made selections and adjustments you want to delete.

At SYSTEM press UP, the unit will display UTILITIES

Press ENTER. The unit will display COMM SETUP.

Figure 20 Buttons