Levelcom 100 - Display, Timing, and SG Setup

To Next Page

To Previous Page

Page 37

Press UP. The unit will display MEMORY.

Press ENTER. The unit will display WRITE OVER BACKUP.

Press UP. The unit will display ERASE ALL MEMORY.

Press ENTER. The unit will display SURE?

Press ENTER. The unit will reset and display SYSTEM.

At SYSTEM continue with programming or press ESCAPE to return to operation with factory

set defaults.

Display Setup

Note: All descriptions of configuring the display assume that the LevelCom 100 is

being configured for the first time after the memory has been erased. If the unit

already has an existing configuration the initial numbers seen when entering the

Maximum Depth and the Bubbler to Bottom values will be different than described in

this procedure.

1. At SYSTEM press ENTER. The unit will display DISPLAY SETUP

2. Press ENTER. The unit will display DEPTH UNITS.

3. Press ENTER. The unit will display INCHES*.

4. Press UP or DOWN to scroll to the depth unit of measure you have chosen for use.

5. Press MENU to select the choice. An asterisk (*) will appear to the right of the display

indicating the item has been selected. If depth is to be displayed in ullage proceed to the

next step, if not then proceed to step 7.

6. Press UP or DOWN to scroll to ULLAGE. Press MENU if you wish depth to be displayed

in ullage. An asterisk (*) will appear to the right of the display indicating the item has

been selected.

7. Press ENTER to save the selection(s). SAVING will appear briefly on the display and the

display will return to DEPTH UNITS indicating the selection has been recorded.

8. Press DOWN. The unit will display VOLUME UNITS.

9. Press ENTER. The unit will display NOT USED*.

10. Press UP or DOWN to scroll to the volume unit of measure you have chosen for use.