Levelcom 100 - Page 38

Page 38
©2013 Technical Marine Service, Inc. LC-100 V2.97
11. Press MENU to select the choice. An asterisk (*) will appear to the right of the display
indicating the item has been selected. If volume is to be displayed in ullage proceed to
the next step, if not then proceed to step 13.
12. Press UP or DOWN to scroll to ULLAGE. Press MENU if you wish volume displayed in
ullage.
13. Press ENTER to save the selection(s). SAVING will appear briefly on the display and the
display will return to VOLUME UNITS indicating the selection has been recorded.
14. Press DOWN. The unit will display WEIGHT UNITS.
15. At WEIGHT UNITS press ENTER. The unit will display NOT USED*.
16. Press UP or DOWN to scroll to the weight unit of measure you have chosen for use.
17. Press MENU to select the choice. An asterisk (*) will appear to the right of the display
indicating the item has been selected. If weight is to be displayed in ullage proceed to the
next step, if not then proceed to step 19.
18. Press UP or DOWN to scroll to ULLAGE. Press MENU if you wish weight displayed in
ullage.
19. Press ENTER to save the selection. SAVING will appear briefly on the display and the
display will return to WEIGHT UNITS indicating the selection has been recorded.
20. Press DOWN. The unit will display DISPLAY UNITS.
Note: DISPLAY UNITS will appear only if either Volume or Weight units were selected. In
the case of depth only being selected the unit will display TANK TABLE.
21. At DISPLAY UNITS press UP or DOWN to scroll to the unit of measure you have chosen for
normal display.
Note: The choice of Display Units will determine the unit of measure the LevelCom 100 will
use to set Alarm Setpoints later in the programming procedure. It may simplify programming
to set the Display Unit as depth until programming has been completed. After the program
has been entered you can return to this point in the program and change the display as
desired.
22. Press MENU to select the choice. An asterisk (*) will appear to the right of the display
indicating the item has been selected.
23. Press ENTER to save the selection. SAVING will appear briefly on the display and the
display will return to DISPLAY UNITS indicating the selection has been recorded.
24. Press DOWN. The unit will display TANK TABLE.