Levelcom 100 - Configure as a Control Output

Page 60
©2013 Technical Marine Service, Inc. LC-100 V2.97
12. Press the UP or DOWN keys to scroll to the MIN SG value you have defined on your
worksheet.
13. Press ENTER. SAVING will appear briefly on the display and the display will shift to MIN
SG.
14. Press the UP or DOWN keys to scroll to MAX SG.
15. Press ENTER. The unit will display 0.0.
16. Press the UP or DOWN keys to scroll to the MAX SG value you have defined on your
worksheet.
17. Press ENTER. SAVING will appear briefly on the display and the display will shift to MAX
SG.
18. Press ESCAPE to return to normal operation.
Configure as a Control Output
1. Enter Program Mode by pressing the MENU key.
2. At SYSTEM press the UP or DOWN keys to scroll to OUTPUTS.
3. Press ENTER. The unit will display LIGHTS.
4. Press the DOWN key until unit displays ANALOG OUTPUT.
5. Press ENTER. The unit will display GAUGE.
6. Press DOWN key until unit displays CONTROL.
7. Press MENU to select this function. An asterisk (*) will appear to the right of the display
indicating the function has been selected.
8. Press ENTER. SAVING will appear briefly on the display. The unit will display MIN
SETPOINT.
9. Press ENTER. The unit will display 0.0.
10. Press the UP or DOWN keys to scroll to the MIN SETPOINT value you have defined on
your worksheet.
11. Press ENTER. SAVING will appear briefly on the display and the display will shift to MIN
SETPOINT.