Page 93
©2013 Technical Marine Service, Inc. LC-100 V2.97
Assuming Big Number = 0 the conversion factors for the other units available in the
LevelCom 100 are as follows:
Gallons = 0.1 liters / 37.85306
K Gallons = 0.1 liters / 37853.06
Liters = 0.1 liters / 10
K Liters = 0.1 liters / 10000
Cubic Feet = 0.1 liters / 283.1605
Barrels = 0.1 liters / 1589.829
These conversion factors must be divided by 10 if the Big Number flag is set and the base
units are liters.
Volume Format
Volume is a long (32 bit) integer. Since the registers are only 16 bits long the volume is
stored in two registers. To get the actual volume registers 30003 and 30004 must be
combined in the following way:
Volume = ( (register 30003) * 65536 ) + (register 30004)
Registers 30006 & 40006 - Status Bits
These registers can be used in place of the 1XXXX coil registers. The bit functions
are defined below.
EPROM Failure 0x0001
Check Air 0x0002
Sense line over pressure 0x0004
Loop failure 0x0008
Sense line leak 0x0010
SG sense line over pressure 0x0020
DP sense line over pressure 0x0040
SG sense line leak 0x0080
Big Number flag 0x0100
HiHi Alarm 0x8000
Hi Alarm 0x4000
Lo Alarm 0x2000
LoLo 0x1000
To Next Page
Loading...