Lexmark X734DE - Page 201

Diagnostic aids 3-5
7526
Go Back
Previous
Next
PRINTER SETUP
Defaults See “Defaults” on page 3-23.
Prt Color Page Count See “Page Counts” on page 3-24.
Prt Mono Page Count
Perm Page Count
Serial Number See “Serial Number” on page 3-24.
Engine Setting 1 through 4 See “Engine Setting 1 through 4” on page 3-24.
Model Name See “Model Name” on page 3-24.
Configuration ID See “Configuration ID” on page 3-25.
Reset Color Cal See “Reset color calibration (Reset Color Cal)” on page 3-26.
Par 1 Strobe Adj See “Parallel 1 strobe adjustment (Par 1 Strobe Adj)” on
page 3-26.
Motor Calibration See “Motor Calibration” on page 3-26.
EP SETUP
EP Defaults See “EP Defaults” on page 3-26.
Fuser Temp See “Fuser temperature (Fuser Temp)” on page 3-27.
DC Charge Adjust See “DC Charge Adjust, Dev Bias Adj, Transfer Adjust” on
page 3-27.
Dev Bias Adj
Transfer Adjust
REPORTS
Menu Settings Page See “Menu Settings Page” on page 3-27.
EVENT LOG
Display Log See “Display Log” on page 3-28.
Print Log See “Print Log” on page 3-28.
Clear Log See “Clear Log” on page 3-29.
EXIT DIAGNOSTICS This selection exits Diagnostics mode, and then Resetting the
Printer displays. The printer performs a POR, and then returns to
normal mode.