Lexmark X734DE - Page 200

3-4 Service Manual
7526
Go Back
Previous
Next
MOTOR TESTS (order differs depending upon model)
Align Motor Test See “General motor tests procedures” on page 3-12.
Cart 1
Cart 2
Cart 3
CAM
COD
DUPLEX
MPF
Transfer Belt
Tray 1
PRINT TESTS
Tray 1 See “Input source tests” on page 3-13.
Tray 2 (if installed)
Tray 3 (if installed)
Tray 4 (if installed)
Tray 5 (if installed)
Multi-Purpose Feeder
Prt Quality Pgs See “Print quality test pages (Prt Quality Pgs)” on page 3-14.
HARDWARE TESTS
Panel Test See “Panel Test” on page 3-15.
Button Test See “Button Test” on page 3-15.
DRAM Test See “DRAM Test” on page 3-16.
Serial 1 Wrap (if a serial port is
available in the PCI slot 1)
See “Serial 1 Wrap” on page 3-16.
USB HS Test Mode See “USB HS Test Mode” on page 3-17.
DUPLEX TESTS (if installed)
Quick Test See “Quick Test (duplex)” on page 3-18.
Print Test See “Print Test (duplex)” on page 3-19.
Top Margin See “Top Margin (duplex)” on page 3-20.
Left Margin See “Left Margin (duplex)” on page 3-20.
Skew See “Skew (duplex)” on page 3-20.
Sensor Tests
Static Sensors See “Sensor Tests” on page 3-21.
Dynamic Sensors
Other Sensors
PRINTHEAD TESTS
Mirror Motor Test See “Mirror Motor Test” on page 3-22.
Servo Laser Test See “Servo Laser Test” on page 3-22.
DEVICE TESTS (if hard disk or flash is installed)
Quick Disk Test See “Quick Disk Test” on page 3-22.
Disk Test/Clean See “Disk Test/Clean” on page 3-23.
Flash Test See “Flash Test” on page 3-23.