4-4 Service Manual
7526
18B0832 Taptite M3 L6
PANHD
5 V interlock switch to rightside frame 1
Card support plate to upper plate 2
Card support plate to lower plate 3
Card support plate (and printhead ground) to leftside frame 5
Card support plate to rightside frame 4
Cartridge left guide assembly to leftside [late (interior side of plate
assembly)
4
COD drive assembly to upper plate 3
COD shaft assembly to upper plate 2
Contacts assembly to leftside frame next to auger worm gear 2
Contacts assembly to leftside frame near duct 2
Duct to frame 4
EP drive to rightside plate (exterior side) 8
Flatbed fan to housing 4
Front door ground wire to rightside frame bracket 1
Ground screws between scanner and printer frame 3
HVPS to leftside frame plate 1
Laser support plate to lower plate 2
Left cam shaft lock assembly to printer frame 2
Left frame assembly to lower plate 4
Left frame assembly to laser support plate 2
LVPS support plate to rightside plate 4
LVPS to rightside frame plate and support bracket 5
Motor driver card to EP drive assembly 2
MP feeder drive cover to rightside frame 3
Rear frame assembly 8
Rear frame assembly to scanner support frame 2
Right cam shaft lock assembly to printer frame 2
Right frame assembly to laser support plate 2
Right frame to lower plate 3
Scanner support frame assembly to left frame 2
System board to RIP plate. 9
Top cover assembly to printer frame 5
Upper plate to rightside frame assembly 3
Upper plate to leftside frame assembly 3
Upper plate to laser support plate 3
18B0939 Plastite M3x6
FLATHD
Gearbox plate assembly to frame 4
Screw identification table (continued)
P/N Screw type Location Qty
To Next Page
Loading...
