Repair information 4-13
7526
f. When the top right and top left alignment marks are both showing and are even on the page, the
skew is aligned.
14. Tighten the printhead mounting screws.
a. Turn off the printer.
b. Disconnect the power cord from the electrical outlet.
c. Disconnect the transfer module cable.
d. Press the two tabs on either side of the transfer module, and lift out the transfer module with the
photoconductor units in place.
e. Remove all of the toner cartridges.
f. Tighten the printhead mounting screws in the following order: G1, G2, and G3.
15. Replace the toner cartridges.
16. Reinstall the transfer module and the photoconductor units.
17. Connect the transfer module cable.
To Next Page
Loading...
