Repair information 4-45
7526
7. Remove the UICC cable from the two cable clamps (F), and the USB cable from the two clamps (G) above
the system board.
8. Open the two clips on the toroid (H) on the UICC.
Note: Be sure to retain the toroid, and reinstall it on the cable when you install the top access cover.
9. Remove the cables through the frame, over the cartridge fan, through the cable clamps (J), and through
the frame towards the front of the MFP.
10.Remove the fuser. See “Fuser assembly removal” on page 4-114.
To Next Page
Loading...
