4-46 Service Manual
7526
11.Remove one screw (K) on the left side and two screws (L) on the right side, that secure the links.
12.Rotate the left and right pivots (M) until they are upright, and then remove them.
Note: If you are removing the top access cover to access another part, leave the top access cover and the
operator panel bezel attached, and you are done. If you need to replace the top access cover FRU, continue
with the next step to remove the separate operator panel bezel FRU.
13. Remove the operator panel bezel. See “Operator panel bezel removal” on page 4-32.
To Next Page
Loading...
