Repair information 4-47
7526
Installation notes:
On the right side—Place the spring in place to hook onto the pivot, and push the pivot back into place securing
the spring on the pivot.
• If the original rib on the right side where the spring was attached is broken off (B) or is no longer there
(newer parts), make sure the spring is oriented so the spring bend is on the bottom (C).
• If the original rib on the right side is present (D), orient the spring to go through the gap in the rib, with the
bend at the top (E).
On the left side—Position the new spring with the bend in the spring down, and slip it over the pivot end. Slide
the pivot back into the original opening.
To Next Page
Loading...
