3-24 Service Manual
7562
Disk Test/Clean
Warning: This test destroys all data on the disk and should not be attempted on a good disk. This test may run
approximately 1½ hours depending on the disk size.
1. From the Diagnostics menu, navigate to:
DEVICE TESTS > Disk Test/Clean
A Contents will be lost warning appears.
2. To exit the test immediately and return to DEVICE TESTS, select No and touch Submit. To continue with
the test, select Yes and touch Submit.
When the test starts, a progress bar appears. The test cannot be stopped or canceled once it has begun.
3. Once the test is complete, the power indicator turns on solid and a message appears indicating whether
the test passed or failed. Press Stop (
X) to return to DEVICE TESTS.
Flash Test
This test causes the file system to write and read data on the flash to test the flash.
Warning: This test destroys all data on the flash because the flash is reformatted at the end of the test.
1. Select Flash Test from DEVICE TESTS From the Diagnostics menu, navigate to:
DEVICE TESTS > Flash Test
A Contents will be lost warning appears.
2. To exit the test immediately and return to DEVICE TESTS, select No and touch Submit. To continue with
the test, select Yes and touch Submit.
When the test starts, a progress bar appears. The test cannot be stopped or canceled once it has begun.
3. Once the test is complete, the power indicator turns on solid and a message appears indicating whether
the test passed or failed. Press Stop (
X) to return to DEVICE TESTS.
To Next Page
Loading...
