EasyManua.ls Logo

Lexmark X792 7562-4xx - Scanner Exposure Lamp Removal

Lexmark X792 7562-4xx
855 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4-222 Service Manual
7562
Go Back
Previous
Next
Scanner exposure lamp removal
See “Flatbed scanner” on page 7-19 for the part number.
1. Remove the correct CCD assembly for the lamp you need to replace. See one of the following:
“ADF duplex CCD assembly removal” on page 4-176
“Flatbed scanner CCD assembly removal” on page 4-221
2. Remove the three screws (A) securing the scanner exposure lamp and cable.
3. Remove the lamp reflector (B) from the CCD assembly.

Table of Contents

Related product manuals