Repair information 4-157
7562
3. Determine if the problem is resolved. Do not perform a normal POR until you are sure you have resolved
the problem.
• If the problem is not resolved, then turn the printer off and reinstall the old part.
• If the problem is resolved, then turn the printer off and turn it back on without holding any buttons
(perform a normal POR).
4. Verify that the input sources are recognized:
a. From the Home screen, navigate to:
Menus > Paper Menu > Paper Size/Type
b. Make sure all installed options are listed.
5. Verify that the output options are recognized:
a. From the Home screen, navigate to:
Menus > Paper Menu > Bin Setup > Output Bin
b. Make sure all installed options are listed.
System board cage with board removal
1. Remove the flatbed scanner assembly. See “Flatbed scanner assembly removal” on page 4-226.
2. Remove the LVPS. See “Low-voltage power supply (LVPS) removal” on page 4-81.
3. Remove two screws (A) to remove the RIP card shield from the system board.
To Next Page
Loading...
