Lexmark X792 7562-4xx - HTU Sensor Cable (Bin-Full Send and Receive) Removal; HTU Stopper Diverter Removal

Repair information 4-407
7562
Go Back
Previous
Next
HTU sensor cable (bin-full send and receive) removal
1. Remove all output options from the printer.
2. Remove both bin-full sensors. See “HTU card (bin-full send card and lens) removal” on page 4-368
and “HTU card (bin-full receive card and lens) removal” on page 4-367.
3. Route the cable through the frame.
HTU stopper diverter removal
1. Remove the front standard bin cover. See “HTU front standard bin cover removal” on page 4-374.
2. Remove the solenoid plunger and spring from the stopper diverter, and then slide the stopper diverter off
the option.