Lexmark X792 7562-4xx - HTU Output bin Solenoid Removal

Repair information 4-385
7562
Go Back
Previous
Next
HTU output bin solenoid removal
1. Remove the rear standard bin cover. See “HTU rear standard bin cover removal” on page 4-394.
2. Disconnect the output bin solenoid cable (A).
Note: Tie a string onto the cable so you can route the new cable through the HTU.
3. Remove the front standard bin cover. See “HTU front standard bin cover removal” on page 4-374.
4. Disconnect the plunger (B) from stopper diverter and the spring (C) from the solenoid.
5. Remove the two screws (D) and remove the solenoid.