Diagnostic information 2-33
7510
956.02
Service system
board
RIP card assembly cooling
fan failure
The RIP card assembly cooling fan is not
functioning properly.
Go to Go to “956.02 RIP card assembly cooling
fan failure” on page 2-177.
956.03
Service system
board
RIP card assembly FPGA
failure
The RIP card assembly has failed.
Go to Go to “956.03 RIP card assembly FPGA
failure” on page 2-177.
980.00
Service tray 2
comm.
Communication error with
1TM, 3TM or TTM assembly
A communication error has occurred with the
1TM,3TM or TTM controller card assembly and the
upper printer engine card assembly.
Go to Go to “980.00 Communication error with
1TM, 3TM, or TTM assembly” on page 2-177.
980.01
Service device
comm
HVPS controller
communication error
A communication error has occurred with the
developer roll HVPS card assembly and the upper
printer engine card assembly.
Go to Go to “980.01 HVPS controller
communication error” on page 2-178.
980.02
Service device
comm
Communication error
between printer and RIP card
assembly
A communication error has occurred with the RIP
card assembly and the upper printer engine card
assembly and the.
Go to “980.02 Communication error between
printer and RIP card assembly” on page 2-179.
980.03
Service finisher
comm
Communication error with
finisher controller card
assembly
A communication error has occurred with the upper
printer engine card assembly and the finisher
controller card assembly.
Go to “980.03 Communication error with finisher
controller card assembly” on page 2-179.
981.00
Service finisher
error
Sensor (stacker bin level 1)
late error
Sensor (stacker bin level 2)
late error
The sensing area of the sensor (stacker bin level 1)
or Sensor (stacker bin level 2) is not interrupted
within the specified period after the stacker bin
starts rising.
Refer to the Finisher Service Manual.
981.01
Service finisher
error
Stacker bin upper limit error The sensing area of the sensor (stacker bin upper
limit) is not interrupted when the stacker bin raises
to its uppermost limit.
Refer to the Finisher Service Manual.
981.02
Service finisher
error
Stacker bin lower limit error The stacker bin lowers beyond the specified lower
limit within the specified time.
Refer to the Finisher Service Manual.
982.00
Service finisher
error
Sensor (front tamper HP) late
error
The sensing area of the sensor (front tamper HP) is
not interrupted when the front tamper starts moving
to the home position.
Refer to the Finisher Service Manual.
982.01
Service finisher
error
Sensor (front tamper HP) lag
error
The sensing area of the sensor (front tamper HP)
remains interrupted within the specified time after
the front tamper starts moving from the home
position.
Refer to the Finisher Service Manual.
Error code or
message
Error contents Description/Action
To Next Page
Loading...
