Lexmark X945 - Transfer Belt Drive Motor Assembly Removal; Switch (Transfer Belt Access Door Interlock) Removal

4-82 Service Manual
7510
Transfer belt drive motor assembly removal
1. Remove the rear cover assembly. See “Rear cover assembly removal” on page 4-5.
2. Remove the rear upper cooling fan bracket assembly. See “Rear upper cooling fan bracket assembly
removal” on page 4-102.
3. Remove the developer / transfer roll HVPS card assembly. See “Developer / transfer roll HVPS card assembly
removal” on page 4-103.
4. Remove the transfer belt drive motor cooling fan. See “Transfer belt drive motor cooling fan removal” on
page 4-81.
5. Disconnect the connector from the transfer belt drive motor assembly (A).
6. Remove the transfer belt drive motor assembly (A).
Switch (transfer belt access door interlock) removal
1. Remove the rear cover assembly. See “Rear cover assembly removal” on page 4-5.
2. Remove the rear upper cooling fan bracket assembly. See “Rear upper cooling fan bracket assembly
removal” on page 4-102.
3. Remove the developer / transfer roll HVPS card assembly. See “Developer / transfer roll HVPS card assembly
removal” on page 4-103.
4. Remove the transfer belt drive motor cooling fan. See “Transfer belt drive motor cooling fan removal” on
page 4-81.
5. Disconnect the connector from the switch (transfer belt access door interlock) (A).
6. Release the hooks securing the switch (transfer belt access door interlock) (A) to the machine.