2-182 Service Manual
7510
Media size mismatch in width
Media size mismatch in width
Step Check Yes No
1 Check the media.
Is media properly loaded in the tray?
Go to step 2. Load media
properly.
2
Check the media.
Is the rear media tray guide, and media tray end guide of tray
1 or tray 2 set correctly?
Go to step 3. Set the guides
properly.
3
Check the switch (media size) for proper installation.
Pull out the media tray to visually check it.
Is the switch (media size) for media tray 1 and media tray 2
installed correctly?
Go to step 4. Install the switch
(media size) for
each media tray
correctly.
4
Check the switch (media size) connection for tray 1 and/or
tray 2.
Is the switch (media size) properly connected for tray 1 and/or
tray 2?
Replace the
required switch
(media size).
Go to “Switch
(media size)
removal” on
page 4-114.
Replace the
connection.
5
Perform a print test.
Does the error continue when the power is turned off/on?
Replace the
upper printer
engine card
assembly.
Go to “Upper
printer engine
card assembly
removal” on
page 4-77.
Problem solved.
Step Check Yes No
1 Check the media.
Pull out the tray, and visually check it.
Is the media loaded in tray properly?
Go to step 2. Load media
properly.
2
Check the media.
Pull out the tray, and visually check it.
Are the front media guide and rear media guide on
tray 3 or tray 4 set correctly?
Go to step 3. Set the parts
correctly.
3
Check the switch (TTM media size) for proper
installation.
Pull out the tray, and visually check it.
Is the switch (TTM media size) for tray 3 or tray 4
installed properly?
Go to step 4. Install the switch
(TTM media size)
correctly.
Go to “2000-sheet
dual input
(TTM)–switch
(TTM media size)
removal” on
page 4-182.
To Next Page
Loading...
