2-176 Service Manual
7510
955.XX RIP card assembly NAND CRC failure
956.00 RIP card assembly processor failure
956.01 RIP card assembly processor over temperature failure
Step Check Yes No
1 Perform a POR.
Does the error occur when the power is turned off/on?
Go to step 2. Perform several
print tests.
If the problem
remains, go to
step 2.
2 Turn the printer off for 60 seconds.
Does the error occur when the power is turned off/on again?
Replace the RIP
card assembly.
Go to “RIP card
assembly
removal” on
page 4-73.
Problem solved.
Step Check Yes No
1 Perform a POR.
Does the error occur when the power is turned off/on?
Go to step 2. Perform several
print tests.
If the problem
remains, go to
step 2.
2 Turn the printer off for 60 seconds.
Does the error occur when the power is turned off/on again?
Replace the RIP
card assembly.
Go to “RIP card
assembly
removal” on
page 4-73.
Problem solved.
Step Check Yes No
1 Perform a POR.
Does the error occur when the power is turned off/on?
Go to step 2. Perform several
print tests.
If the problem
remains, go to
step 2.
2 Turn the printer off for 60 seconds.
Does the error occur when the power is turned off/on again?
Go to step 3. Problem solved.
3 Check the RIP card cooling fan and heatsink for proper
installation.
Is the RIP card cooling fan and heatsink installed correctly?
Replace the RIP
card assembly.
Go to “RIP card
assembly
removal” on
page 4-73.
Install the RIP
card cooling fan
and heatsink
correctly.
To Next Page
Loading...
